Vent for the basement bathroom

It was long overdue, but I finally installed a vent for the basement bathroom. It was inspired by Nick taking showers down there. Getting into the basement took a lot more work than I anticipated.

It was more than my hole saw would handle, so I had to do it in pieces.  But eventually I made it through. I caulked the back of the vent and attached it to this perfect piece of vinyl that I found at Menards.

Then I just attached some duct to both ends and now the fan vents outside instead of into my basement.  I think I am going to get a timer for the fan so you can just press a button when you start showering and it will run for a half hour or so.  Otherwise I could see it getting left on, or turned off too soon.

The other half of the patio, finally!

Finally got around to putting in the other half of the concrete patio off the basement doors.  I was putting it off because I wanted to replace the post and put in a standoff at the bottom.  However, the post is in perfect condition on this side and I figured I needed to get it done before the snow flies.  So I put the kids to work!

Maddie wanted to add a tablet under the concrete in case anyone every jackhammered it up!

It came out pretty well, there are a few more pebbles on top then I would like and I still haven't figured out how to get the hardener to show up and the release agent to go away.  But it matches the other side well.  I think I might seal the concrete now, I will have to see.

I wonder if there is something I can put around the hot tub to keep water away from the base.

Wiring up Ethernet for Nick

Nick has been after me for a while to run ethernet to his room, he is convinced it will be far superior to the wireless ethernet he is using now.  I haven't been in a big hurry, because I need to run a cable through the attic, and it is dusty up there.

However, Maddie started guitar lessons and that left Nick and me home for 2 hours and he wanted to do it, so we did.  He did most of the wiring in the panel and his room, I braved the attic though.

The amazing thing is that the wired connection is about 10x faster, when doing a speed test to our NAS.  The wireless speed is just as fast as the WAN connection about 100mbps, but with the wired connection it gets almost the full 1gbps that our network is capable of.

So, most of the time it won't make a difference, but when transferring files to the NAS it is a lot faster.  The location of the ethernet port in his room necessitated the purchase of a right angle ethernet cable, so we could push his dresser up against it.

Yuck! Faucet has been leaking for awhile!

After working through the aforementioned issues in the previous posts we happened upon some water in the middle of the basement.  Jen then noticed that it was coming from the floor above at the kitchen sink.

Since there was a plethora for "stuff" in the cabinet we hadn't noticed a problem until this water in the basement, but when we removed everything we could see that we had quite the mess under the sink.  It appears that the faucet has been leaking for quite awhile, the bottom of the shelf was mushy and black.

So it was time to replace the faucet.  Unfortunatly, the nuts had rusted and were difficult to remove.  Basically I ended up breaking them.  It was not a fun task under the sink with a mucky floor.  Eventually got it off though.

Not sure what all this is, probably minerals from the water...  Not a good look in any case...

The old shut off values wouldn't turn anymore, so I cut them off and soldered on new one.  I have to make sure that the pipes are still properly positioned so that they drain in the winter.  These pipes will move up and down now.

Once the old faucet was off and the new turn off values installed the faucet installed easily and Nick did most of the work.  It is nice to be able to hand off projects to other people.  I am hoping that the new faucet will drain properly, so we might be getting a new one.  The guy at Menards said this is their busiest time of the year!

 

New Life for the Water Heater

When we came up earlier this year we had to hot water, so we had to boil water on the stove to do dishes.  Not ideal!  I was thinking I was going to have to put in a new water heater, but I stopped by Appliance Depot and he recommended that I just check out the connections with a multimeter first.

Once I started doing a little reading I realized it might not be so bad.  The first thing I measured was the voltage at the heating element.  That is the bottom part with 2 wires going to it.  It measured 240V, so I knew the breaker was fine.

Then I shut off the breaker and did a continuity check, which resulted in no continuity.  I checked the bottom element as well and there was continuity there.  So I determined that the heating element needed to be replaced.

I could buy 1 heating element for $20 or a pack with 2 plus the thermostat for $25.  So I went with the later.

They normally have a 1.5 inch water heater heating element wrench that you can buy for $7, however they were out of them at the time.  So I went with $65 dollars worth of a socket and breaker bar.  I don't feel too bad about returning them after I used them, and I will pick up the $7 wrench when they are back in stock as it seems like something useful to have around with my spare heating element.
 

Here you can see the old heating element.  Not sure what happened to it, but it no longer has continuity.  Also interesting that it was a lot shorted then the new ones.  Same wattage though, which appears to be the important part.

Overall a simple fix and a big relief.  I wonder if I need to check the sacrificial rod in the water heater and if that could have caused the issue with the heating element.  I will have to read into that.

New Bunk Bed

We had ordered a bunkbed for the back bedroom at the cabin just about exactly a year ago and it finally came in.  I had hoped to use it in the winter when we don't open up the Eagle Nest.  But we didn't make it up this winter, so it wasn't a big lose.

Jen and Maddie worked on this project and did it almost entirely on their own.  I only helped with lifting the twin bed over the full bed.  They did a great job and it was comfortable to sleep on, and will provide for an extra bed in the future!

 

Toilet Trouble

We went up to the cabin for the second time this year so we had an idea of some of the issue we were looking forward to.  You can see the toilet fill mechanism cracked, so we had to manually control the shutoff value to fill the tank.

Fortunately, the fix was an $8 part from Menards.  It was a simple fix and Nick handled this one all by himself while I was working on other issues!