Wednesday, September 1, 2010

A/C Installation (IV)

At this point we turned the value on the compressor to release the refrigerant into the line set and A-coil <DO NOT DO THIS>. I was outside and heard a loud hiss as I opened the value and some liquid drip out the bottom of the larger pipe in the line set. I immediately shut the value back down and the hissing slowed and eventually stopped. It was about 8pm at that point so we decided to wrap it up for the day, and call for some help in the morning.

The next day I called Wenzel heating and cooling and amazingly was able to get an appointment for the afternoon, I asked about cost and was told it will be a $99 fee for him to come out. In the afternoon the guy comes out and I explain what has happened, the first thing he asks is who sold me the system... He didn't think anyone would sell an R410A system to someone who didn't know exactly what they were doing.

The first thing he explained was that after attaching the line set you have to pull a vacuum on it to clear the humid air out of the system. He was worried that I had contaminated the compressor and he would have to pull a vacuum on that as well, but after I explained that I closed the value after I heard the hiss he thought we would be OK.

He heated up all the joints we had done with an acetylene touch to make sure the solder had flowed throughout the joint, and actually was impressed that we had been able to do what we did with what we had. Then he pulled a vacuum on the line set and A-coil while I threaded a 2 wire 18 gauge cable to connect from the furnace control board to the compressor. You connect to the C and Y points on the circuit board.

A/C Installation (III)

The brazing is an interesting process, you basically have to heat the metal to the point where the silver sodier will wick into the joint. The copper turned bright red, and still the silver you melt a bit, but they stick to the pipe. We were using a Mapp gas torch and eventually a butane one as well to try and keep the heat up.

You braze the line set to the evaporator line on the A-coil, and you braze a fitting to the line set for the compressed line. The A-coil has some components on the compressed size that could melt if they are heated up enough to braze (would be my guess).

You then have to braze the line set to the compressor on the outside of the house. This is fun because you have the compressor nice and close to the house so that it is out of the way. We had to drill a hole in the side of the house (always a fun process) and string the line set through the joists.

Part IV